A SERVICE OF

logo

10
Part Names and Functions
Rear Terminal
S-VIDEO IN
Connect the S-VIDEO output signal from video
equipment to this jack (p.18).
AUDIO IN
Connect the audio output signal from video
equipment connected to or to this jack.
For a mono audio signal (a single audio jack),
connect it to the L (MONO) jack (p.18).
COMPUTER 1 COMPONENT / COMPUTER 2
AUDIO IN
Connect the audio output (stereo) from a
computer or video equipment connected to ,
or to this jack. (pp17, 19)
VIDEO IN
Connect the composite video output signal to
this jack (p.18).
COMPUTER IN 1 / COMPONENT IN
Connect output signal from a computer, RGB scart
21-pin video output or component video output to
this terminal (pp.17,19).
AUDIO OUT (VARIABLE)
Connect an external audio amplifier to this jack
(pp.17-19).
This terminal outputs sound from AUDIO IN terminal
( or ).
LAN Connection Terminal
Connect the LAN cable (refer to the owner’s manual
of “Network Set-up and Operation”).
USB Connector (Series B)
In order to operate the computer with the remote
control and use the PAGE ▲▼buttons on the
remote control during a presentation, connect the
USB port of the computer to the USB terminal with a
USB cable (not supplied) (p.17).
USB Connector (Series A)
Connect the USB menory (refer to the owner’s
manual “Network Set-up and Operation”).
CONTROL PORT
When controlling the projector with RS-232C,
connect the control equipment to this connector with
the serial control cable.
R/C JACK
When using the wired remote control, connect
the wired remote control to this jack with a remote
control cable (not supplied).
HDMI
Connect the HDMI signal (including sound signal)
from video equipment or the DVI signal from
computer to this terminal (pp.17, 19).
COMPUTER IN 2 / MONITOR OUT
– Connect computer output to this terminal (p.17).
– This terminal can be used to output the incoming
analog RGB signal and component signals from
COMPUTER IN 1/COMPONENT IN terminal to the
other monitor (p.17).
*
is registered trademarks of HDMI
Licensing, LLC.
*