Sanyo WTC500L Manual

A SERVICE OF

next previous

58

Setting

Shutter

Shutter function is available to block out light to the

screen, so that the screen can be used for the other

presenters.

Prohibits the shutter operation from the remote control

and the projector's top control.

Remote control ... Selecting "On" prohibits the shutter

operation from the remote control.

Projector . . . . . ... Selecting "On" prohibits the shutter

operation from the top control.

It is possible to prohibit the shutter operation from both of

the remote control and the top control.

Protection

Management

The Shutter Management function turns off the projection

lampwhen the projector is left with the shutter closed and

the set time has passed away. The count-down time can be

set between 5 and 180 minutes. When the count-down time

has elapsed, the shutter will be opened up automatically and

the lamp will be turned off to cool itself down. The SHUTTER

indicator is blinking blue during this cooling-off period. When

the lamp has been fully cooled down, the READY indicator

turns green lighting and the SHUTTER indicator keeps

blinking. Should the ON / STAND-BY button be pressed in

this condition, the projection lamp will be turned on and the

SHUTTER indicator turns off.

✔Note:

 •TheFactory default valueisset to180minutes

forthecountdowntime.

 •The ShutterManagementfunction cannot be

halted.

HDMI setup

Set Image and Sound according to the output signal of video

equipment. Press the Point 7 8 buttons to switch between each

option.

Image ...Normal : When the output of video equipment is

set to “Normal.”

Enhanced : When the output of video equipment is

set to “ENHANCED.”

Sound...HDMI : Select when use PCM AUDIO (DIGITAL

AUDIO)

AUDIO1: Select when use AUDIO1 input

The names for the output setting of video equipment vary from

equipment to equipment. For details, refer to the owner’s manual

of video equipment.

When the black part of the image are destroyed or stand out,

please switch to "Normal" or "Enhanced"

according to the output

signal of video equipment.

HDMI setup

Press the Point 7 8 buttons

to select Normal or Enhanced

according to the output signal

of video equipment and HDMI

or Audio1 according to the input

sound.

✔Note:

 •HDMIsetupisnotgrayoutandinoperative

otherthanHDMIinputselectionmode.