Sanyo PLC-WL2500 Manual

A SERVICE OF

next previous

54

Remote control

Thisprojector providestwodifferentremote controlcodes:

thefactory-setinitialcode(Code 1)andthesecondarycode

(Code 2).Thisswitchingfunctionpreventsremotecontrol

interference when operating severalprojectorsorvideo

equipmentatthesametime.

WhenoperatingtheprojectorinCode 2,boththeprojector

andtheremotecontrolmustbeswitchedtoCode 2.

To change the code for the projector:

SelecteitherCode 1orCode 2inthisSettingMenu.

To change the code for the remote control:

PressandholdboththeMENUandIMAGEbuttons

togetherfor5secondsormore.Afterchangingthecode,

makesuretheremotecontroloperatesproperly.

Note:

•Whendifferentcodesaresetontheprojectorandonthe

remotecontrol,anyoperationcannotbemade.In

that

case,switchthecodeontheremotecontroltofitthecode

ontheprojector.

•Ifthebatteriesareremovedfromtheremotecontrolfora

longperiodoftime,theremotecontrolcodewillbereset.

Thisfunctionallowsyoutochangebrightnessofthescreen.

Normal......Normalbrightness.

Eco ...........Lowerbrightnessreducesthelamppower

consumptionandextendsthelamplife.

Setting

Lamp control

Remote control