15
BEFORE OPERATION
To insure safe operation, please observe the following precautions :
● Use (2) AA, UM3 or R06 type alkaline batteries.
● Replace two batteries at the same time.
● Do not use a new battery with a used battery.
● Avoid contact with water or liquid.
● Do not expose the Remote Control to moisture, or heat.
● Do not drop the Remote Control.
● If a battery has leaked on Remote Control, carefully wipe case clean and install new batteries.
● Risk of explosion if battery is replaced by an incorrect type.
● Dispose of used batteries according to the instructions.
Press lid down-
ward and slide it.
Remove the battery
compartment lid.
Slide the batteries
into compartment.
Replace the compartment lid.
Two AA size batteries
For correct polarity (+ and
–), be sure battery
terminals are in contact
with pins in compartment.
REMOTE CONTROL BATTERIES INSTALLATION
1
2
3
Operating Range
Point the Remote Control toward
projector (Infrared Remote
Receiver) whenever pressing any
button. Maximum operating
range for Remote Control is about
16.4’ (5m) and 60° in front and
rear of the projector.
16.4’
(5 m)
60°
16.4’
(5 m)
Used to operate P-TIMER
function. (P21)
