Setting the DVD-VCR Output Channel
Selecting the RF OUT Sound Mode (G-K )
GB
23
VCR
VCR
Your DVD-VCR output channel may need to be changed if the
pictures suffer from interference or if your TV cannot find the
pictures.
Also, you can change the DVD-VCR output channel to adjust the
frequency in which information is displayed on the screen.
1 After pressing the MENU, press the OK or
❿
.
Result
: The Setup menu is displayed.
2 Press the corresponding
#
,
❷
buttons to select the Install
option.
3 Press the OK or
❿
to select this option.
Result
: The Install menu is displayed.
4 Press the
#
or
❷
buttons, until the VCR Output CH option
is selected.
5 Select the required output channel (CH21~CH69) by pressing
the OK or
❿
buttons.
CH21 .. CH36 .. CH69
6 On completion, press RETURN three times to exit the menu.
Then tune your television again (see page 14).
You can choose the sound mode (G-K) according to the TV set
connected to your VCR.
1 After pressing the MENU, press the OK or
❿
.
Result
: The Setup menu is displayed.
2 Press the corresponding
#
,
❷
buttons to select the Install
option.
3 Press the OK or
❿
to select this option.
Result
: The Install menu is displayed.
4 Press the
#
or
❷
buttons, until the TV System option is
selected.
5
Press the
OK or
❿
buttons to select G or K.
6 On completion, press RETURN three times to exit the menu.
