Page 8
Fig. 11Fig. 10
When used for jig saw mounting, this kit can be used with all
Ryobi jig saws, plus most other brands of jig saws. Proper
mounting of the jig saw base to the clamping brackets will
determine which saws will work. The jig saw must be mounted
securely for safety.
TO ASSEMBLE JIG SAW TO MOUNTING PLATE
See Figure 10.
1. Figure 10 illustrates the correct orientation of parts and
pieces for mounting your jig saw to its mounting plate.
2. The front of jig saw should be facing the squared end of
mounting plate, while the rear of saw faces mitered
corners.
3. The front clamping bracket (formed bracket) mounts on
the squared end of mounting plate. Therefore, front
clamping bracket will secure front of jig saw base to
mounting plate.
4. The rear clamping bracket (flat bracket) mounts on the
end with mitered corners and secures rear of jig saw
base to mounting plate.
Hint:
5. Loosely attach front and rear clamping brackets to
mounting plate using the #10-24 x 3/4 in. flat head
screws provided. Note: Thread head of screws thru
countersunk side of mounting plate.
JIG SAW MOUNTING
6. Place mounting plate upside down on a flat workbench
and position jig saw under front and rear clamping
brackets. We suggest that you tilt your saw forward and
slide front of base under front clamping bracket. Next,
lower rear of jig saw down on mounting plate and place
rear bracket on rear of saw base.
7. Carefully invert this set-up and snugly tighten clamping
bracket screws.
TO ADJUST JIG SAW ON MOUNTING PLATE
See Figure 11.
1. Once properly assembled and adjusted, your jig saw
and mounting plate assembly should be similar to the
illustration shown in figure 11.
2. If adjustments are required, loosen clamping bracket
screws and adjust jig saw as needed.
3. We suggest that you always begin by sliding screws to
the rear of front slot in mounting plate and adjust as
needed. This will prevent saw blade from coming in
contact with the throat plate, mounting plate, accessory
table, etc. when installed.
4. After all adjustments have been made, tighten clamping
bracket screws securely.
JIG SAW
MOUNTING PLATE
#10-24 SCREWS
REAR
CLAMPING
BRACKET
JIG SAW
BASE
JIG SAW
#10-24 SCREWS
(CLAMPING BRACKET SCREWS)
REAR SLOT
FRONT SLOT
FRONT
CLAMPING
BRACKET
