Installation Instructions 40” Roller Bar Mower Kit
MANUFACTURING, INC.
500 N Spring Street / PO Box 997
Port Washington, WI 53074-0997 USA
Form No. 1733901
Revision: 02
TP 200-4519-02-SK-N
Briggs & Stratton Yard Power Products Group
Copyright © 2007 Briggs & Stratton Corporation
Milwaukee, WI USA. All Rights Reserved
Install Height Adjustment Trunnion
Note: Attaching the trunnion to the inner hole provides
lift operation with minimal effort, but with average below
surface operation. Attaching the trunion to the outer hole
provides maximum below surface roller travel, but with
greater effort for operation.
1. Attach height adjust trunnion (A, Figure 7) to bar
extension (B) and secure in place with the hair pin
clip(C). Re-attach the 4-link chain (D) to hangers on
the frame as before using only three links.
3. Repeat step 2 for opposite side of mower.
Figure 7. Install Height Adjustment Trunnion
A. Trunnion, Height Adjustment
B. Extension, Bar
C. Clip, hair pin
D. Chain, 4-Links
A
B
C
D