USED WHEN REPLACING THESE ITEMS.
1. To rem ove the fan, remove 3
screws securing the fan/
mounting plate to the vent box.
2. To remove the fan from the
mounting plate, remove the 4
screws.
3. Refit in reverse order.
4. To change the flue and air
intake orientation from back to
top, remove the fan/mounting
plate as explained in Steps 1
and 2.
5. Remove intake and exhaust
cover(s) from top of the heater.
6. Rotate the fan, mounting plate
and gasket clockwise until the
flue adapter lines up with the
top hole. Secure with 3 screws.
7. R em o ve the flexible duct from
the air intake adapter on the
back.
8. Remove the air intake adapter
from the back of the heater.
Install in the appropriate hole
on top.
9. Reconnect the flexible duct.
10.Install intake and exhaust
cover(s) over the holes on the
back of the heater.
11. Ensure sealed joints. Ensure
mounting plate orifice is clear
and not obstr
ucted.
