A SERVICE OF

logo

9
Wet/Dry Vac Assembly
1.Position the powerhead assembly on
the drum/caster foot assembly as
shown (assembled earlier).
2.Rotate both latches down and press
until you hear them snap over the
flanges on the drum.
Drum
Latch
Drum
Latch
Drum
Flange
Latch
Drum
Powerhead
Assembly
Insert Hose
Insert the push button end of the “Dual-
Flex™ Locking” hose into the inlet of the
Vac.The hose should snap into place.
To remove the hose from the Vac, press
the release button in the hose assembly
and pull the hose out of the Vac inlet,
as shown.
Press
and
Pull
Release
Button
SP6735-3 RIDGID ES 6/13/12 2:35 PM Page 9