TECH SPRAY, INC. MATERIAL SAFETY DATA SHEET
P O BOX 949 RS 64-4321 Aerosol
88 NORTH HUGHES
AMARILLO TX 79105
(806) 372-8523
* * * * * * * VI--SPILL OR LEAK PROCEDURES * * * * * * *
-------------------------------------------------------------------------
Evacuate area. Ventilate area well and avoid breathing vapors. Vapor
concentration will be highest along the floor and in low lying areas.
Pick up the liquid on a suitable absorbant and store in sealed
containers.
* * * * * * * VII--WASTE DISPOSAL METHODS * * * * * * *
-------------------------------------------------------------------------
Material may be disposed of by a licensed reclaimer or incineration
facility. Consult local, state, and federal disposal authorities for
approved procedures.
Do not incinerate or destroy aerosol cans.
* * * * * * * VIII--EMPLOYEE PROTECTION * * * * * * *
-------------------------------------------------------------------------
Respiratory Protection:
If levels exceed TLVs, increased ventilation or an organic vapor mask
may be required.
Ventilation: Do not use in closed space. Ventilation required.
Hands: Solvent-resistant gloves such as Viton(R)*, Polyvinyl alcohol.
Eyes: Wear splash-proof safety goggles or glasses.
Special Precautions:
Keep aerosol cans in cool place out of direct sunlight. Keep this and
all chemicals out of reach of children. This product is intended for
industrial use only.
* * * * * * * IX--OTHER INFORMATION * * * * * * *
-------------------------------------------------------------------------
TSCA Inventory Status: Reported/Included.
The cold fill of the product is approximately 4.5 oz (127.58g).
* Viton(R) is a registered trademark of DuPont Dow Elastomers
-------------------------------------------------------------------------
Prepared By: R. Moore Date: 05-27-93
NL=Not Listed NIF=No Information Found NE=Not Estabilished
NA=Not Applicable
Page 3 of 3
