The Integrated Answering Device
29
1. Press MENU/CLOCK three times in standby
mode.
You hear “Ring time” and the current ring time
([ ] two, [ ] four, [ ] six, [ ] Toll saver), and it
is displayed on the base. Then you hear the
guidance for setting the ring time.
2. Press
/VOL/SEL or /VOL/SEL until the
desired ring time appears.
3. Press
SET to select the new ring time. You hear
a confirmation tone. Then the announcement
“Ring time” and the new ring time is
announced. After a few seconds, the system
announces “To set record time, press menu
again”.
Selecting the Message Record Time
You have three record time options. The options
“
one minute” or “four minutes” set the duration for
recording the incoming messages. “
Announce only”
answers the call with the preset greeting or your
personal greeting but prevents the caller from
leaving a message.
1. Press
MENU/CLOCK four times in standby
mode.
You hear “Record time” and the current
recording time ([ ] one minute, [ ] four
minutes, [ ] Announce only, No recording),
and it is displayed on the base. Then you hear
the guidance for setting the record time.
2. Press
/VOL/SEL or /VOL/SEL until the
desired time appears.
3. Press
SET to select the new recording time.
You hear a confirmation tone. Then the
announcement “Record time” and new
recording time is announced. After a few
seconds, the system announces “To set
message alert, press menu again”.
43-3857.book Page 29 Wednesday, February 18, 2004 12:40 PM
