5
Small
Holes
Spool
Hub
Line in Notch
Line in Notch
Line exit holes
S
Wind the line evenly and tightly onto the
spool. Wind in the direction of the arrows
found on the spool.
S
Push the lines into the notches, leaving 3 to
5 inches (7 -- 12 cm) unwound.
S
Insert the lines into the the exit holes in the
hub as shown in the illustration.
S
Align the notches with the line exit holes.
S
Push spool into hub until it snaps into place.
S
Pull the lines extending outside of the hubto
release the lines from the notches.
REPLACING THE CUTTING HEAD
S
Push in locking lever and hold.
S
Rotate dust cup until the locking lever falls
into one of the grooves
.
Locking Lever
S
Continue to hold in locking lever. This will
prevent the shaft from turning while remov-
ing and installing trimmer head.
S
Remove trimmer head by turning clock-
wise.
S
Thread replacement trimmer head onto the
shaft by turning counterclockwise. Tighten
until secure.
S
Release locking lever.
SERVICE
We recommend all service and adjustments
not listed in this manual be performed by an
Authorized Service Dealer.
CARBURETOR ADJUSTMENTS
Your carburetor is equipped with limiter caps.
Carburetor adjustment is a complicated task.
We recommend that you take your unit to an
Authorized Service Dealer. Damage will oc -
cur if you turn the needles beyond the limiter
stops.
IGNITION TIMING
The ignition timing is fixed, non-adjustable.
SPARK PLUG
Replace the spark plug yearly using a Cham-
pion RCJ--8Y plug. Spark plug gap is 0.025”.
NEED ASSISTANCE?
Need Assistance?
Call 1-800-554-6723.
Need Service Parts?
Contact your dealer.
