13
SCALPING -- The scalping technique r emoves
unwanted vegetation down to t he ground. Hold
the bottom of the trimmer head about 3 in. (8
cm) above theground and atan angle. Allow t he
tip of the line to strike the ground around trees,
posts, monuments, etc. This technique in-
creases line wear.
Scalping
MOWING -- Your trimmer is ideal for mowing
in places conventional lawn mowers cannot
reach. In the mowing position, keep the line
parallel to the ground. Avoid pressing the
head into th e ground as this can scalp the
ground and damage the tool.
Mowing
SWEEPING -- The fanning actionof the rotat-
inglinecanbe usedto blowaway loose debris
from an area. Keep the line parallel to and
above the area surface and swing the tool
from side to side.
Sweeping
MAINTENANCE
WARNING: D isconnect the spark
plug before performing maintenance except
for carburetor adjustments.
HELPFUL TIP
IMPORTANT: Have all
repairs other than the rec-
ommended maintenance
described in the instruction
manual p erformed by an
authorized service dealer .
If any dealer o ther than an authorized
service dealer performs work on the
product, Poulan PRO may not pay for
repairs under warranty . It is your re-
sponsibility to maintain and perform
general maintenance.
CHECK FOR LO OSE
FASTENERS AND PARTS
S Spark Plug Boot
S Air F ilter
S Housing Screws
S Assist Handle Screw
S Debris Shield
CHECK FOR DAMAGED OR
WORN PARTS
Contact an authorized service dealer for re-
placement of damaged or worn parts.
S ON/STOP Switch -- Ensure ON/STOP
switch functions properly by pushing and
releasing the switch. Make sure en gine
stops. Wait 5 seconds before attempting to
restart unit to allow switch to reset. Restart
engine and continue.
S Fuel Tank -- Discontinue use of unit if fuel
tank shows signs of damage or leaks.
S Debris Shield -- Discontinue use of unit if
debris shield is damaged.
INSPECT AND CLEANUNIT ANDDE-
CALS
S After each use, inspect complete unit for
loose or damaged parts. Clean the unit and
decals using a damp cloth with a mild deter-
gent.
S Wipe off unit with a clean dry cloth.
CLEAN AIR FILTER
A dirty air filter decreases engine perform-
ance and increases fuel consumption and
harmful emissions. A lways clean after every
5 hour s of operation.
1. Clean thecover and the area around it to
keep dirt from falling into the carburetor
chamber when the cover is re moved.
2. Remove parts by pressing button to re-
lease air filter cover.
NOTE: To avoid creating a fire hazard or
producing harmful evaporative emissions, do
not clean filter in gasoline or other flammable
solvent.
3. Wash the filter in soap and water .
4. Allo w filter to dry.
5. Replace parts.
Button
Air Filter Cover
Air Filter
