A SERVICE OF

logo

Open as PDF
next previous
6
75 ⍀
75 ⍀
2
1
A
combination antenna receives
normal broadcast channels
(VHF 2-13 and UHF 14-69).
Your connection is easy since
there is only one 75Ω (ohm)
antenna plug on the back of your
TV - and that’s where the antenna
goes.
If your antenna has a round
cable (75 ohm) on the end, then
you're ready to connect it to the TV.
If your antenna has flat twin-lead
wire (300 ohm), you first need to
attach the antenna wires to the screws
on a 300 to 75 ohm adapter.
Push the round end of the
adapter (or antenna) onto the 75Ω
plug on the rear of the TV. If the
round end of the antenna wire is
threaded, screw it down finger tight.
BASIC ANTENNA SIGNAL CONNECTIONS
BEGIN
ANTENNA
Remember:
Be sure to set the
TV for the type sig-
nal you've connect-
ed (see the “Cable”
section on page 11
of this manual.)
To set the TV to
select only the chan-
nel numbers in your
area see how to
“Program" or "Add"
channels in the TV’s
memory on page 12
(Auto Program sec-
tion).
To order any option-
al accessory contact
your dealer or the
Philips Parts Center
at 1-800-851-8885.
SMART
HELP
300 to 75Ω
Adapter
Combination VHF/UHF
Antenna
(Outdoor or Indoor)
Twin Lead
Wire
Round Cable
75Ω
Back of TV
OR
Note: For homes with separate UHF and VHF antennas
you will need an optional combiner to connect to the TV.
75 ⍀
U/V
Combiner
75-300 Ohm Adapter
Back of TV
If no Video Signal is present, the TV will
display a “BLUE” screen and shut itself off
in about five minutes. If the TV is tuned to
the AV channel and there is no Video
Signal present, the screen will remain
black, then the TV will shut itself off in
about five minutes.