MASTERCOLOR
®
Philips MasterColor
®
Ceramic Metal Halide HPS-RetroWhite
™
Lamps
featuring ALTO
®
LampTechnology
Ordering Data
ANSI Rated Approx. Approx.
Product Nom. Ballast Avg.Life Initial Mean
Number Ordering Code Watt. Code (Hrs.)
1
Lumens
2
Lumens
3
HPS-RetroWhite Lamps Rated forVertical Operation Only
13093-0 CDM250S50/V/O/4K/ALTO
4
250 S50/M168/O 20,000 20,500 16,400
1
3094-8 CDM400S51/V/O/4K/ALTO
4
4
00 S51/M169/O 20,000 34,800 27,840
H
PS-RetroWhite Lamps Rated for Horizontal Operation Only
1
4649-8 CDM250S50/HOR/4K/ALTO
4
2
50 S50/M168/O 20,000 20,500 16,400
1
4650-6 CDM400S51/HOR/4K/ALTO
4
4
00 S51/M169/O 15,000 34,800 29,600
R
ECOMMENDEDWARNINGS,CAUTIONS,
AND OPERATING INSTRUCTIONS
R
W
ARNING:“These lamps can cause serious skin burn and
eye inflammation from short wave ultravioletradiation if
outer envelope ofthe lamp is broken or punctured.Do not use
w
here people will remain for morethan a few minutes unless
a
dequateshielding orother safety precautions are used.Certain
l
amps that will automatically extinguish when the outer envelope
i
s broken or punctured are commercially available.”This lamp
c
omplies with FDA radiation performance standard 21 CFR
subchapter J.(USA:21CFR 1040.30 Canada:SOR/ DORS/80-381).
Ifthe outer bulb is brokenor punctured,turn offat once
andreplace thelampto avoid possible injury from
hazardous short wave ultraviolet radiation.Do not
s
cratch the outerbulborsubjectittopressureasthis
c
ouldcausetheouterbulbtocrackorshatter.A partial
vacuumin the outer bulbmay cause glass tofly if the
e
nvelopeis struck.
W
ARNING:The arc-tube of metal halide lamps aredesigned to
operate under highpressure and at temperatures up to 1000ºC
and can unexpectedlyrupture dueto internal orexternal factors
suchas a ballast failure or misapplication.If the arc-tube ruptures for
a
ny reason,the outer bulbmaybreakand piecesof extremely hot
g
lass might be discharged into thesurrounding environment.Ifsucha
r
upturewere to happen,THERE ISA RISK OF PERSONAL
I
NJURY,PROPERTY DAMAGE,BURNSAND FIRE.
These lamps are designed to retain all the glass
particles should an arc tube rupture occur.The following
operating instructions are recommended to minimize
these occurrences.
RELAMPFIXTURESAT OR BEFORETHE ENDOF
RATED LIFE.Allowing lamps to operate until they fail is
not advised and may increase thepossibility of inner arc
t
uberupture.Thislamp contains an arctube with afilling
gascontaining lessthan 25 nCi ofKr-85 and is distributed
b
yPhilipsLightingCompany,a divisionofPhilipsElectronics
NorthAmericaCorporation,Somerset,NewJersey,08875.
C
AUTION:TO REDUCETHE RISK OF PERSONAL INJURY,
PROPERTYDAMAGE,BURNSANDFIRE RESULTING FROMAN
A
RC-TUBE RUPTURETHEFOLLOWING LAMP OPERATING
INSTRUCTIONS MUSTBE FOLLOWED:
LAMP OPERATING INSTRUCTIONS:
1) RELAMP FIXTURESAT OR BEFORETHE END OF RATED
LIFE. Allowinglamps to operate untilthey fail is notadvised and
may increasethe possibility of inner arc tuberupture.
2) Beforelamp installation/replacement,shut power off andallow
lamp and fixture to coolto avoid electrical shockand potential
burn hazards.
3) UseonlyauxiliaryequipmentmeetingPhilipsand/orANSIstandards.
Use within voltage limits recommended byballast manufacturer.
A.Operate lamp only within specified limits of operation.
B.For total supply load refer toballast manufacturers
electrical data.
4) Periodically inspect the outer envelope.Replace any lamps that
showscratches,cracks or damage.
5) If a lamp bulb support is used,be sure to insulatethe support
electrically to avoid possible decomposition ofthe bulb glass.
6) Protect lamp base,socket and wiringagainst moisture,corrosive
atmospheres andexcessive heat.
7) Time should beallowedfor lampsto stabilize in color when
turned onfor the first time.This may require several hours of
operation,with more than one start.Lamp color isalso subject
to change under conditions ofexcess vibrationor shock,and
color appearance may vary betweenindividual lamps.
8) Lamps may require 10 to 20 minutes tore-light ifthere is a
power interruption.
9) Take care in handlingand disposing of lamps.Ifan arc tube is
broken,avoidskin contact with any of the contents or fragments.
1) Rated average lifeis the life obtained,on theaverage,from large representative groups oflamps in laboratory testsunder controlled
conditions at10 or more operating hours perstart.Itis based onsurvival of atleast 50%of the lampsand allowsfor individual lamps
or groupsof lampsto vary considerably from theaverage.
2
)Approximatelumen values listedare forverticalor horizontal operation oflamp,respectively,asindicated inchart.
3
)Approximatelumen output at40% oflamp rated average life.
4) Notforuse in compact“wallpack”or“floodlight”typefixtures.Maximumtemperaturelimitof outerbulbmaybe exceededin these
applicationsand canleadto prematurelamp failure.
V=Vertical operation ±15º.Do notoperate inhorizontal position.
HOR =Horizontaloperation ± 15º.Do not operate in avertical position.
A
NSI Code:O=Open Fixture Rated
ALTO
®
LampTechnology
Abovespecifications subject to changewithout notice.
Physical Characteristics
Bulb Size –––––––––––––––––––––––––––––––ED18
Bulb Finish ––––––––––––––––––––––––––––––Clear
Base––––––––––––––––––––––––––––––––––––Mog.
Max.Overall Length (MOL)–––––––––––––––––9.75''
Light Center Length (LCL)––––––––––––––––––5.75"
Operating Characteristics
C
olorTemperature (K) –––––––––––––––––––4000K
C
RI ––––––––––––––––––––––––––––––––––––––85
© 2007 Philips Lighting Company.All rights reserved.
Printed in USA 07/07
P-5497-F
www.philips.com
Philips Lighting Company
200 Franklin Square Drive
P.O.Box 6800
Somerset,NJ 08875-6800
1-800-555-0050
ADivision ofPhilipsElectronics NorthAmericaCorporation
Philips Lighting
281 Hillmount Road
Markham,Ontario
Canada L6C 2S3
1-800-555-0050
ADivision ofPhilipsElectronics Ltd.
Printed onchlorine freepaper from Sappi FinePaper mills,who areaccredited withEMAS environmental certification.
Sappi claims thatthe pulp used inthe manufactureof MagnoDull paper is derived from environmentallycertified forests.
Dimensions
A ––––––––––––––––––––––––––––––––2.25"/57mm
B (LCL) ––––––––––––––––––––––––––5.75"/146mm
C (MOL)–––––––––––––––––––––––––9.75"/248mm
1
00
8
0
60
40
2
0
0
400 450 500 550 600 650 700
Relative Energy
W
avelength — nanometers
Spectral Power Distribution: MasterColor
®
HPS-Retro White™
LCL = Light Center Length
MOL= Maximum Overall Length
P5497F_HPS_Retro_White_Bulletin.qxd:product bulletin 3/6/08 11:45 AM Page 2
