>
When operation time reaches the last 100 hours of the average lamplife, the message ‘Warning:
lamplife has almost expired’ will be displayed on the screen, each time the projector is switched
on.
The lamplife remaining can be checked using the OSD menu.
1 Press Menu.
– The menu bar appears on the screen.
2 Use Cursor Control to select Lamp counter in the ‘Set up’ menu.
– The used lamplife hours are displayed.
– When the lamplife has expired the message ‘Warning: lamplife has expired’ is displayed on
the screen.
1 Switch off the projector and wait until the lamp has cooled down (about 5 minutes) before
disconnecting the projector. Remove the mains lead from both projector and wall socket.
The mains lead must be disconnected from the projector otherwise the lamp door
cannot be removed.
2 Turn the projector over. Never place the projector on the side where the connections are
located!
3 Remove the lamp door, using a screwdriver.
– When the lamp door is removed the mains inlet socket will be partly closed. The lamp door
therefore cannot be removed if the mains lead is not disconnected from the projector.
4 Read the caution and warning labels on the lamp holder.
Lamp
Lamp replacement
Philips Multimedia Projector 32 English User guide bClever SV1
6. Maintenance
S-VIDEO
DATA
VIDEO
PICTURE SIZE – PICTURE SIZE +
VOLUME +
VOLUME –
SOURCE
MENU OK
PICTURE SIZE – PICTURE SIZE +
VOLUME +
VOLUME –
SOURCE
AV MUTE
MENU OK
STANDBY
OKMENU
MUTE
ZOOM
VIDEO
FREEZE
STAND BY
S-VIDEO
COLOUR TRACKING
CONTRASTBRIGHTNESS
DATA
PICTURE SIZE
PICTURE FORMAT
AV MUTE
INFO
KEYSTONE
KEY LOCK
S-VIDEO
DATA
VIDEO
MENU
PICTURE SIZE – PICTURE SIZE +
VOLUME +
VOLUME –
SOURCE
OK
PICTURE SIZE – PICTURE SIZE +
VOLUME +
VOLUME –
SOURCE
AV MUTE
STANDBY
MENU OK
