A SERVICE OF

logo

Open as PDF
next previous
30
 [LPCM Output] - Select the LPCM (Linear
Pulse Code Modulation) output sampling rate.
 [48kHz] - For discs recorded at sampling
rate of 48 kHz.
 [96kHz] - For discs recorded at sampling
rate of 96 kHz.
Note
[LPCM Output] setting is only available if the [Digital
Output] is set to [PCM Only].
The higher the sampling rate, the better the sound
quality.
[HDMI Audio]
Select the HDMI audio setting when you connect
this product and the TV with an HDMI cable.
 [On] - Allow audio output through the TV and
the speaker system. If the audio format on the
disc is not supported, it will be downmixed to
two-channel sound (linear-PCM).
 [Off] - Disable audio output from the TV.
The sound is only output through the speaker
system.
[Audio Sync]
Set the delay time for audio output when you play
a video disc.
1. Press OK.
2. Press
to set the volume.
3. Press OKWRFRQÀUPDQGH[LW
[Volume]
Set the default volume level when you play a disc.
1. Press OK.
2. Press
to set the volume.
3. Press OKWRFRQÀUPDQGH[LW
[Sound Mode]
Select a preset sound effect to enhance the audio
output.
 [3D] - Select a virtual surround sound effect
that is produced from the left and right audio
channels.
 [Movie Mode] - Select a sound effect for
movies.
 [Music Mode] - Select a sound effect for
music.
[CD Upsampling]
For better sound quality in stereo mode, convert
the music CD to a higher sampling rate.
[Auto standby]
Turn on or off automatically standby.
 [On] - Switch to standby 15 minutes of
inactivity (for example, in pause or stop mode).
 [Off] - Disable the auto standby mode.
[DivX(R) VOD Code]
Display the DivX
®
registration code.
Tip
8VHWKLVSURGXFW·V'LY;UHJLVWUDWLRQFRGHZKHQ\RXUHQW
or purchase video from www.divx.com/vod. The DivX
videos rented or purchased through the DivX
®
VOD
(Video On Demand) service can be played only on the
device to which it is registered.
Audio setup
1 Press SETUP.
» [General Setup] menu is displayed.
2 Press to select [Audio Setup], then press .
3 Select an option, then press OK.
4 Select a setting, then press OK.
To return to the previous menu, press 
.
To exit the menu, press  SETUP.
[Analogue Output]
Select an analogue setting based on the audio
device that is connected through the analogue
audio jack.
 [Stereo] - For stereo output.
 [LT/RT] - For surround sound output through
two speakers.
[Digital Audio]
6HOHFWDGLJLWDOVHWWLQJEDVHGRQWKHGLJLWDODPSOLÀHU
receiver that is connected through the digital jack
(coaxial/digital).
 [Digital Output] - Select a type of digital
output.
 [Off] - Disable digital output.
 [All] - Support multi-channel audio
formats.
 [PCM Only] - Downmix to two-channel
audio format.
EN