15
Satellite Receiver with a recorder
& Connect the RF Antenna or Cable TV cable 1 to
the
RF IN socket of your recorder.
é Connect another RF cable 2 from the output of
your recorder to the TV’s 75 ø x jack.
“ Connect the satellite antenna cable 3 to the
satellite receiver’s
SATELLITE IN jack.
‘ Connect the AV cables 4 to the satellite receiver’s
AV OUT jacks and to the VCR’s AV IN jacks.
( Connect the recorder’s AV OUT jacks 5 to the TV’s
AV2 IN jacks.
DVD player or other accessory digital source equipment
Equipment with AV connectors only
& Connect the video cables to the equipment’s
AV OUT jacks and to the TV’s AV1 or AV2 IN
jacks.
é Connect the audio cables to the equipment’s
AUDIO L and R jacks and to the L AUDIO and
R AUDIO AV1 or AV2 jacks on the TV.
(According to where you connected the video
cables, to
AV1 or AV2.)
Equipment with an
S-VIDEO connector
& Connect an S-video cable the AV2
S-VIDEO input.
Note:When using the s-video connector do not
connect any device to the video input.
é Connect the audio cables to the equipment’s
AUDIO L and R jacks and to the L AUDIO and
R AUDIO AV2 jacks on the TV.
With Component Video Output Connectors
& Connect the cables of your YPbPr equipment
1 to the
YPbPr input AV1 IN sockets on the
TV.
Note:The YPbPr sockets on the TV are compatible
with 480i (interlaced, 1 Fh) output signals only, not
480p (progressive scan, 2 Fh).
é For reproduction of CVI (Component Video
Input) and in order to have correct picture
reproduction, also connect a video cable to
video of
AV1 2.
Note:This connection is used for
AV1 (CVBS).
“ Connect the Audio left and right (only for
stereo devices) cables 2 to the
AUDIO L and
R input of AV1.
Remark: Equipment may also be connected to the
AV IN jacks (SIDE) at the right side of the TV.
Warning: Never connect a signal to the Y-input
and video-input at the same time.This may
cause picture distortion !
Equipment with Progressive scan output
(480p or 1080i 2 Fh)
Connect the equipment to the
AV4 IN jacks on
the TV.
See
AV3 or AV4 Digital HD input, next page.
Note:The labels for the component video sockets
may differ depending on the DVD player.Although
the abbreviations may vary, the letters B and R
stand for the blue and red component signals,
respectively, and Y indicates the luminance signal.
Refer to the DVD player’s instructions for use for
definitions and connection details.
AV 2
in
AV 1
in
Monitor
out
VIDEO
L
R
Y
Pb
Pr
AUDIO
S-VIDEO
REC
CABLE
SAT
≈
IN OUT
SAT
IN
OUT
IN
OUT
AV 2
in
AV 1
in
Monitor
out
VIDEO
L/Mono
R
Y
Pb
Pr
AUDIO
S-VIDEO
5
75
3
4
2393.2 en.qxd 06-09-2004 11:19 Pagina 15
