A SERVICE OF

logo

Open as PDF
next previous
Main panel with bracket.
1. Disconnectthe strain relief of the AC power cord.
2. Disconnect the degaussing coil by removing thecable from (red) connector 0201 [1].
3. Remove the panel bracket from the bottom tray,by pulling it backward [2] and turn the
chassistray 90 degrees counter clockwise.
4. Move the panel somewhat to the left and flipit 90 degrees [3], with the components
towardsthe CRT.
5. Turn the panel with the rear I/O towardsthe CRT.
6. Place the hook of the tray in the fixation holeof the cabinet bottom [4] and secure it.
Pa
g
e 3 of 7SPMS
7/8/2004