A SERVICE OF

logo

Open as PDF
next previous
Figure 12. Tightening the Thumbscrews
Figure 13. Installing the Cable Management Bracket
18 C3683M (3/09)
12. After the unit is in place, tighten the two thumbscrews to secure the unit to the rack.
13. Install the cable management bracket on the rear panel as follows (refer to Figure 13):
a. Position the bracket so that the screw holes on the unit and bracket are aligned.
b. Insert two 6-32 x 0.25-inch Phi
llips pan head screws (supplied) into the screw holes located on each side of the unit.
c. Tighten the two screws.
d. Attach the three cable clips (supplied) to the cable management bracket.
14. Position the NSM5200 power supply cords along the cable management bracket, and then close the cable clips. You can also use cable ties
(not supplied) to bundle the power supply cords.
THUMBSCREW