C2681M (2/08) 25
Operation
INDICATORS
The EW5001 has a set of six indicators on its rear panel (refer to Figure 20). These indicators show unit status during startup and normal
operation.
Figure 20. EW5001 Status Indicators
INDICATORS DURING STARTUP
During the startup sequence, the unit steps through a number of phases. The color of the MODE indicator shows the status of each phase:
• Green: The phase was completed successfully.
• Amber: The phase is in process. When this indicator is amber, the indicator for the phase will blink.
• Red: An error occurred that could not be corrected. The unit halts the startup process.
Table C shows the color and state of each indicator during startup.
If the Endura network is in secure mode, LED 5 will keep blinking. As soon as you manually add or accept the EW5001 onto the Endura network
from an Endura workstation, LED 5 will stop blinking. Refer to the Endura WS5000 Advanced System Software Operation manual (C1624M) for
more information about secure mode.
NOTE: LED 3 is unused on the EW5001.
Table C. Indicators During Startup
Startup Phase MODE12345
Initializing boot loader. Off Off Off Off Off Off
Boot loader initialized. Amber Off Off Off Off Off
Initializing operating system and unit hardware. Amber Blinking Off Off Off Off
Operating system and unit hardware initialized. Amber On Off Off Off Off
Receiving network address (only when using Endura DHCP server). Amber On Off Off Blinking Blinking
Received network address (either static or from DHCP server). Green On Off Off On Blinking
Access point: Activating radio.
Bridge: Connecting to peer bridge.
Green On Blinking Off On Blinking
Access point: Radio activated.
Bridge: Peer bridge connected.
Green On On Off On Blinking
Connecting to SM5000 on Endura network. Green On On Off On Blinking
Connected to SM5000. Green On On Off On On
STATUS
INDICATORS
