Pelco, Inc. Worldwide Headquarters 3500 Pelco Way, Clovis, California 93612 USA
USA & Canada Tel (800) 289-9100 Fax (800) 289-9150
International Tel +1 (559) 292-1981 Fax +1 (559) 348-1120
www.pelco.com
Pelco and the Pelco logo are registered trademarks of Pelco, Inc. ©Copyright 2009, Pelco, Inc. All rights reserved.
5. Using the pull handle, gently remove the failed power supply from the unit.
Figure 2. Removing the Power Supply
6. Position the replacement power supply so that the cord receptacle is on the left side of the unit.
Figure 3. Replacing the Power Supply
7. Gently push the replacement power supply into the unit until it locks into place.
8. Turn the captive thumbscrew clockwise to tighten it.
9. Connect the power cord for the replacement power supply as follows:
a. Connect the power cord to the receptacle on the replacement power supply.
b. Connect the power cord to the power source.
10. Verify that the indicator on the newly installed power supply glows green. The power supply alarm will stop.
REVISION HISTORY
Manual # Date Comments
C4611M 10/09 Original version.
WARNING: For safety, you must plug the power cord into the power supply before plugging it into the wall socket or other power source.
The materials used in the manufacture of this document and its components are compliant to the requirements of Directive 2002/95/EC.
This equipment contains electrical or electronic components that must be recycled properly to comply with Directive 2002/96/EC of the European Union
regarding the disposal of waste electrical and electronic equipment (WEEE). Contact your local dealer for procedures for recycling this equipment.
