"BACK-FOCUS SETUP" screen
The back focus setting type is selected and fine adjustment is performed. The following setting
is performed on the "BACK-FOCUS SETUP" screen through the top screen. Refer to pages 21 -
22 for how to call up the screen. The lens adjustment (☞ pages 16 - 17) shall be performed
before the back focus adjustment.
<Back focus adjustment>
The back focus adjustment is performed by changing the distance between the lens and focal
point.
Important:
• The auto back focus function is used for back focus adjustment at installation and for focus
correction at switching between the color and black-and-white modes after installation. This
function is not a function that is supposed to be operated continuously such as the auto
focus function.
• When focus missing occurs due to secular change in the lens and installation environment
or peripheral temperature change, the back focus adjustment is required again.
Note:
The back focus adjustment can be also performed through the operation buttons. (☞ page
9)
Back focus setting [BACK-FOCUS SETUP]
Step 2
To fine adjust the back focus, move the cur-
sor to "MANUAL-ADJ", press the setting but-
ton, and use the right or left button to adjust
the back focus manually.
Notes:
• Pressing the right and left buttons simul-
taneously resets the back focus position
to the CS mount default position.
• The value of "INDICATOR" is a guide to
adjust the back focus. The larger the
value is, the sharper the image becomes.
Step 3
Move the cursor to "C/L ←→ B/W" and select
the back focus adjustment type from the fol-
lowing:
Note:
"ABF" is available when "SENS UP" is set
to "OFF", "X2 AUTO", or "X2 FIX".
Step 1
Move the cursor to "PUSH SW" of "ABF" and
press the setting button.
→ The auto back focus function provides
back focus adjustment to automatically
focus on a subject located in the center
of the screen.
