22
RQT804
RQTX1097
ESPAÑOLESPAÑOLESPAÑOLESPAÑOLESPAÑOL
Using sound effects
Changing the sound quality:
Preset EQ
Press [PRESET EQ] repeatedly to select
your desired setting
.
HEAVY Adds punch to rock
CLEAR Clarifi es higher frequencies
SOFT For background music
VOCAL Adds gloss to vocal
FLAT No effect
Changing the sound quality:
Manual EQ
1 Press [MANUAL EQ] repeatedly to select
your desired setting.
BASS For lower pitch sound
MID For middle pitch sound
TREBLE For higher pitch sound
2 Press
[2/3] or [5/6]
to adjust
the level.
Note:
• The level of the pitch is between -4 to +4.
• The changes you make are stored and
automatically recalled the next time you select
“MANUAL EQ”.
Enhancing the stereo sound:
SURROUND sound
Enables you to add natural width and depth to the
stereo sound.
To activate
Press and hold [− SURROUND] to display
“ ” indicator.
To cancel
Press and hold [− SURROUND] again to clear
“ ” indicator.
Note:
• Surround sound is less discernible when listening
through headphones.
• If interference in FM stereo reception increases,
cancel the surround sound effect.
7 Press [R/T] to select the desired
recording storage location.
8 Press [OK] to confi rm.
To activate the timer
9 Press [# PLAY/REC] repeatedly to turn
on your desired timer.
# PLAY # REC
No display (off)
10 Press [`] to turn off the unit.
The unit must be turned off for the timer to
operate.
Change the
settings
Repeat steps 1 to 8 and 10
(Z page 21 and above).
Change the
volume
1) Press [# PLAY/REC] to clear the
timer indicator from the display.
2) Make changes to the volume.
3) Perform steps 9 and 10.
Check the
settings
Press [CLOCK/TIMER] repeatedly to
select # PLAY or # REC.
Cancel
Press [# PLAY/REC] to clear the
timer indicator from the display.
Note:
• The play timer will start at the preset time with
volume increasing gradually to preset level.
• The record timer will start 30 seconds before the
set time with the volume muted.
• The timer comes on at the set time every day if the
timer is on.
• The unit must be in the standby mode for the timer
to function.
• If you turn the unit off and on again while a timer
is functioning, the fi nish time setting will not be
activated.
AKX50_EB_EN.indd 22AKX50_EB_EN.indd 22 6/8/2010 5:25:28 PM6/8/2010 5:25:28 PM
