39
● PS·Data Connection
1. Set the unit address of the recorder to 5 or larger.
2. Set the [Camera control] setting to “PSD” for all cameras in SETUP MENU of the recorder.
3. Connect the unit’s CAM OUT 1 to 16 connectors to the recorder’s VIDEO IN 1 to 16 connectors with a coaxial cable.
4. Connect the unit’s DATA4 Port connector to the recorder’s DATA port with a modular cable.
Select the recorder’s new unit address, which is set in Step 1, in 600 RECORDER of SETUP MENU or the Recorder window
of WJ-SX150A Administrator Console. (Refer to this unit’s operating instructions.)
Notes:
• Select the PS·Data protocol for the DATA 4 setting.
(Refer to this unit’s operating instructions.)
• If the recorder’s unit address, set in Step 1, and the recorder setting, set in Step 5, are different, the recorder will not be
operable.
• Do not connect the recorder to the DATA HDR port.
• From system controllers connected to the unit, you cannot control the recorder.
• Only one matrix switcher can be connected in the PS·Data mode.
SIGNAL GND
POWER
AC IN
CAMERA
1
1
2
2
3
3
2
DATA 3 DATA 2
SERIALALARM
TERM
OFF ON
4
2
1
4
3
CAMERA
SW IN
RS485(CAMERA)
LINE
SELECT
MONITOR OUT
EXT IN
(PLAY IN)
EXT OUT
(REC OUT)
OUT
IN
4
4
5
5
6
6
7
7
8
8
9
9
10
10
11
11
12
12
13
13
14
14
15
15
16
16
RS485(CAMERA)
DATA 4DATA HDR
PS•DATA
DATA 1
12
IN
OUT
CASCADE
OUT
16
16
3
15
15
14
14
13
2
1
13
12
12
11
11
10
10
9
9
8
8
7
7
6
6
5
5
4
4
3
3
2
2
1
1
VIDEO
AUDIO IN AUDIO OUT
MONITOR OUTCASCADE IN
MONITOR (VGA) ALARM/CONTOROL
SERIAL ALARM
POWER
COPY 1
MODE
EXT STORAGE10/100BASE-TRS485(CAMERA)
DATA
AC IN
SIGNAL GND
1
4 2
MONITOR OUT
Monitor
MonitorMonitor
System controller
(Terminal Mode)*
System controller
(PS·Data)
DATA 4*
(PS·Data)
MONITOR
OUT x
MONITOR
OUT z
DATA
Matrix Switcher
Recorder*
* Recorder control from system controllers connected to the matrix switcher is not available.
