(ENG) VQT5E64 35
The Wi-Fi connection is not recognising my PC.
●
By default, the Wi-Fi connection uses the default workgroup name of “WORKGROUP”.
If the name of the workgroup has been changed, it will not be recognised. Select [PC
Connection] then [Change Workgroup Name] in the [Wi-Fi Setup] menu to change the
workgroup name to match that of your PC.
The GPS status indicator lights up while the camera is turned off.
●
[GPS Setting] is [ON].
→ Electromagnetic waves from the camera can affect instruments and meters. In airplane
cabins (during takeoff and landing) or in other restricted areas, set [Airplane Mode] to
[ON], and then turn off the camera.
Positioning takes time.
●
When using the camera for the first time or after not using it for a while, positioning may
take several minutes.
●
Positioning usually takes less than two minutes, but because the positions of the
GPS satellites change, it may take longer depending on the recording location and
environment.
→ Positioning can be executed faster when you download GPS assist data to the camera
using the “GPS Assist Tool”.
●
Positioning will take time in environments where it is difficult to receive the signals from
the GPS satellites.
The location name information is different from the recording location.
●
Immediately after the camera is turned on or when the GPS icon is something other than
[
], the location name information that is recorded in the camera may vary significantly
from the current position.
●
When [ ] is displayed for the location name information, the information can be
changed to a different candidate before starting to record. You can edit a place name or
landmark name recorded in a picture.
Please refer to “Operating Instructions for advanced features (PDF
format)” for details.
