12 Quick Setup
We recommend that you use a
✔ Bi-directional parallel
printer cable. Purchase a cable
marked “IEEE 1284 compliant.”
✔ To comply with FCC regula-
tions, the cable must be shielded
and UL and CSA approved.
5 Connect to Your Computer
■ Insert the other end into the
parallel port on your computer
and tighten the screws.
■ Install the power cord into the
printer receptacle, then into an
outlet.
■ Turn power ON.
Note: OKIDATA has tested and
approved the following bi-
directional cable: Part Number
70000803. See page 21 for
purchasing information.
■ Make sure both your printer
and computer are OFF.
■ Insert the wide connector into
the parallel port on your
printer, then snap both wire
clips into the notches on the
cable connector.
