1515
1515
15
VERSION 1.0 VERSION 1.0
VERSION 1.0 VERSION 1.0
VERSION 1.0
1. Decide the levels desired.
2. Enter the First Level in the Depth / Time boxes and
press DIVE
3. Enter the Second Level in the Depth / Time boxes and
press DIVE
4. Enter the Third Level in the Depth / Time boxes and
press DIVE
As many levels as desired may be entered. They can start
out with operational descent stops or they can map out
the contour of a deep wreck or cave site. The possibilities
are endless!
After the final leg of the dive is entered move to the
Decompress section. Look at the Ceiling next to the final
DIVE button. This will be the first stop area.
PRESS the DECO button and the decompression is
calculated.
To perform the decompression calculations using All
Available Gases that have been selected in the GAS SET
UP, confirm that there is a 0 in the “Decompress to a
Depth:” area and press DECO.
NAUTILUS will calculate decompression and perform
gas shifts are the appropriate levels based on the
maximum PO2 selected in the PREFERENCES tab. A
general Depth / Time schedule will appear to the right of
the dive graph.
From here, the user can either SAVE the dive profile by
pressing the SAVE button or press RESET and start all
over again.
2.4.2 CREATE A MULTILEVEL PROFILE DIVE
Creating a Multi Level Profile with NAUTILUS takes just
a little more work but is still quite simple.
Muti-level ProfileMuti-level Profile
Muti-level ProfileMuti-level Profile
Muti-level Profile
Illustrated in runtime.Illustrated in runtime.
Illustrated in runtime.Illustrated in runtime.
Illustrated in runtime.
