1) Insert a pre-recorded tape into another VCR for playing.
2)
Insert a tape with its record tab into this unit for recording.
3) Press [SPEED] on the remote control of the recording
unit to select the desired recording speed (SP/SLP).
4) Select the “L1” or “L2” position on the recording unit.
• To use the input jacks on the back of this unit, select
“L1” position by pressing [0], [0], [1] on the remote
control or [
CHANNEL
K
/
L
]
on this unit.
• To use the input jacks on the front of this unit, select
“L2” position by pressing [0], [0], [2] on the remote
control or [
CHANNEL
K
/
L
] on
this
unit
.
5) Press [RECORD] on the recording unit.
6) Begin playback of the tape in another source.
Hint
• For best results during dubbing, use the front panel controls whenever pos-
sible. The remote control might affect another source’s operation.
• Always use video-quality shielded cables with RCA-type connectors. Standard
audio cables are not recommended.
• You can use a video disc player, satellite receiver or other audio/video
component with Audio / Video outputs.
• “L1” or “L2” is found before the lowest memorized channel. (Example: CH02)
• “L2” input jacks are on the front of this unit.
Copying a Video Tape
7) To stop recording, press [STOP/EJECT C A] on the
recording unit, then stop playback of the tape in another
source.
