9
Chapter 4: Configuring the PrintServer Using the Setup Wizard
Installation
Wireless-G PrintServer for USB 2.0
8. The Wireless Settings screen will appear. In the SSID field, enter your wireless network’s SSID or name. This
is the unique name shared by all devices in a wireless network. The SSID is case-sensitive and should have
32 characters or fewer.
Select the channel at which the network broadcasts its wireless signal (available only if you selected Ad-Hoc
for the Network Type setting).
The Network Type setting shows a choice of two wireless modes. Select Infrastructure if you want the
PrintServer to communicate using an access point or wireless router. Select Ad-Hoc if you want the
PrintServer to communicate without using an access point or wireless router.
Click the Next button to continue.
Figure 4-7: Wireless Settings
Ad-hoc: a group of wireless devices
communicating directly to each other (peer-to-
peer) without the use of an access point.
Infrastructure: configuration in which a
wireless network is bridged to a wired network
via an access point.
SSID: your wireless network’s name.
