18
Chapter 5: Configuring the ADSL2 Modem
Diagnostics
ADSL2 Modem with USB and Ethernet
Diagnostics
Ping Test. This feature is used to find out if an IP Address is operating and available to receive and respond to
traffic.
• Ping Target IP. Enter the IP Address that you want to ping in the field. This can be either a local (LAN) IP or an
Internet (WAN) IP address.
• Ping Size. Enter the size of the ping packets.
• Number of Pings. Enter the number of times that you want to ping.
Click the Start Test button to start the Ping Test. Click the Clear button to remove the results from the screen.
Factory Default
Restore Factory Defaults. If you wish to restore the Modem to its factory default settings and lose all your
settings, click Yes.
To begin the restore process, click the Save Settings button to save these changes, or click the Cancel Changes
button to undo your changes.
Figure 5-10: Ping Test
Figure 5-11: Restore Factory Default
IMPORTANT: Restoring the ADSL2 Modem's
factory default settings will erase all of your
settings and replace them with the factory
defaults. Do not reset the ADSL2 Modem if you
want to retain the settings.
