A SERVICE OF

logo

4. Make sure the notch 1 on the new memory module is aligned correctly with
the connector key 2 on the socket. Insert the memory module straight down
into the connector until it snaps into position and the retaining clips are closed.
5. Go to “Completing the FRU replacement.” on page 104.
Removing and replacing a PCI adapter
This section provides information and instructions for replacing a PCI adapter.
1. Open the cover. See “Opening the cover” on page 90.
2. Pivot the drive bay assembly upward to gain access to the system board.
3. Remove all cables from the cable clip attached to the PCI riser.
Chapter 8. Replacing FRUs 93