Chapter 3 Using the Operator Panel
3-17
When the desired maximum number of jobs is set,
press the ENTER key.
Press the
MENU
key. The display returns to Ready.
Q
QQ
Q Maximum Space Assigned to Temporary Code Jobs
This changes the hard disk space that holds temporary code
jobs. You can change the maximum space from 0 to 9999
(megabytes). The actual maximum size depends on the size of
free hard disk space, however. The default size is 1/6 of the to-
tal hard disk space, rounded off in units of 50 MB. For example,
if the total hard disk space is 3.2 GB, the default size is 500 MB.
Press the
MENU
key.
Press the 3 or 4 key repeatedly until e-MPS > ap-
pears.
Press the 2 key.
Press the 3 or 4 key repeatedly until >e-MPS Con-
figuration > appears.
Press the 2 key.
Press the 3 or 4 key repeatedly until >>Temp. Code
JOB Size appears.
To change the maximum disk space, press the ENTER
key. A blinking cursor (_) appears.
Press the 3 or 4 key to increase or decrease, respec-
tively, the value at the blinking cursor. Use the 2 and
1 keys to move the cursor right and left.
When the desired size is displayed, press the ENTER
key.
Press the MENU key. The display returns to Ready.
Q
QQ
Q Maximum Space Assigned to Permanent Code Jobs
This changes the hard disk space that holds permanent code
jobs. You can change the maximum space from 0 to 9999
(megabytes). The actual maximum size depends on the size of
free hard disk space, however. The default size is 1/6 of the to-
tal hard disk space, rounded off in units of 50 MB. For example,
if the total hard disk space is 3.2 GB, the default size is 500 MB.
Press the MENU key.
Press the 3 or 4 key and select e-MPS >.
Press the 2 key.
Press the 3 or 4 key repeatedly until >e-MPS Con-
figuration > appears.
Press the 2 key.
Press the 3 or 4 key and select >>Perm. Code JOB
Size.
Press the
ENTER
key, the message display shows a
blinking cursor (_).
Press the 3 or 4 key to increase or decrease, respec-
tively, the value at the blinking cursor. Use the 2 and 1
keys to move the cursor right and left.
When the desired size is displayed, press the ENTER
key.
Press the MENU key and the message display returns
to Ready.
e-MPS >
>e-MPS >
Configuration
>>Temp. Code JOB
Size 0500MB
>>Temp. Code JOB
Size 050
0MB
9
10
1
2
3
4
5
6
7
8
9
10
e-MPS >
>e-MPS >
Configuration
>>Perm. Code JOB
Size 0500MB
>>Perm. Code JOB
Size 050
0MB
1
2
3
4
5
6
7
8
9
10
