8
Are you ready to give your transceiver a quick try?
Reading this section should get your voice on the
air right away. The instructions below are intended
only as a quick guide. If you encounter problems
or there is something you would like to know more,
read the detailed explanations given later in this
manual.
YOUR FIRST QSO
1
Press
[
]
(Power) briefly to switch the transceiver
power ON.
• A high pitched double beep sounds and a Power-on
message appears momentarily. The various indicators
and the current operating frequency appear on the LCD.
• The transceiver stores the current parameters when it is
turned OFF and automatically recalls those parameters
the next time you turn the transceiver ON.
2
Turn the
Volume
control clockwise, to the 12 o’clock
position.
3
Turn the
Tuning
control to select a reception
frequency.
• You may further turn the
Volume
control to adjust the
volume level of the signal.
4
To transmit, hold the microphone approximately 5 cm
(2 inches) from your mouth.
5
Press and hold Mic
[PTT]
, then speak in your normal
tone of voice.
6
Release Mic
[PTT]
to receive.
7
Repeat steps
4
,
5
, and
6
to continue
communication.
1
2
3
6
5
