Symptom Cause Correction
The DVD+VCR does not
start playback.
No disc is inserted.
No tape is inserted.
•
•
Insert a disc or tape. (Check that the
disc or tape indicator in the display
window is lit.)
•
An unplayable disc is inserted.
• Insert a playable disc. (Check the
disc type and Regional code.)
•
The disc is placed upside down.• Place the disc with the playback side
down.
•
The disc is not placed within the
guide.
• Place the disc on the disc tray cor-
rectly inside the guide.
•
The disc is dirty.• Clean the disc.•
Video tape cannot be
inserted.
Is the cassette compartment empty?
• Eject the tape in.•
No Hi-Fi sound Audio mode is not set properly.
• Select STEREO by repeatedly
pressing A.MONITOR on the remote
control.
•
The remote control does
not work properly.
There is an obstacle in the path of
the remote control and this unit.
• Remove the obstacle.•
The batteries in the remote control
are exhausted.
• Replace the batteries with new ones.•
The remote control is not pointed at
the remote sensor of the DVD+VCR.
• Point the remote control at the
remote sensor of the DVD+VCR.
•
The remote control is too far from the
DVD+VCR.
• Operate the remote control within
23 ft (7m).
•
This remote control use the same
buttons for VCR and DVD functions
(ex. PLAY).
• When using a VCR, first press the
VCR button. When using a DVD, first
press the DVD button.
•
Camcorder image is not
shown.
Camcorder is off.
• Turn camcorder on and operate
properly.
•
Camcorder image via AV
input to DVD+VCR is not
shown on TV screen.
DVD+VCR SOURCE SELECT is not
set to LINE1 or LINE2.
• Press AUX to select LINE input
channel (LINE1 or LINE2).
•
Timer recording is not
possible.
Clock in DVD+VCR is not set to cor
-
rect time.
• Set clock to correct time. •
Timer has been programmed incor-
rectly.
• Reprogram Timer. •
indicator light does not appear
after programming timer.
•
Reprogram Timer and turn
DVD+VCR off to enable timer.
•
33
Reference
