Continued on Next Page
SB-M-3-SPD/10W3v3 INSTR_SKU# 011255
S T E P 1 4
Place foam floor supports into cargo area as shown.
Note that the foam supports have been
changed since this photograph was taken
to multiple square blocks.
If you are installing this Stealthbox® enclosure into a
MazdaSpeed3, please skip to step number 20.
Steps 14-19 Apply ONLY to the Mazda 3
S T E P 1 3
Place spare tire on top of enclosure and secure with 3/8 X 1
bolt, flat washer, and original spare tire flange.
S T E P 1 2
From under vehicle, install fender washers, lock washers, and
3/8x16 nuts to mounting studs. Put some silicone sealent
between the vehicle body and, fender washer, tighten
securely.
Page 3 • JL Audio, Inc 2008
S T E P 1 6
Identify 10-inch long Velcro® strip provided. Cut (2) 3-inch
long sections and (4) one inch sections. Remove backing
from “hook”3-inch sections and attach to tool panel as
shown.
S T E P 1 8
Remove backing from 1-inch sections that were placed
above. Set provided passenger side cargo floor panel into
place over Velcro® strips and press downward to engage
Velcro® and adhere to panel back. Place remaining 1-inch
“loop side” Velcro strips onto the LEFT ends of attached
3-inch “hook” strips as shown and, remove adhesive backing.
S T E P 1 7
Place two 1-inch sections of the “loop side” of the Velcro
on RIGHT hand end of each 3-inch section as shown (white
squares). Press down to lock sections together.
S T E P 1 5
Put tool panel into place as shown.
Note that the foam supports have been
changed since this photograph was taken
to multiple square blocks.
