STEP 17
Back out the socket cup set screws so 1 1/4-inch of threads
are exposed.
Place the Stealthbox
®
into position by guiding the socket
cup set screws through the holes drilled.
STEALTHBOX WALL
THREADED INSERT
VEHICLE SHEET METAL
FENDER WASHER
SOCKET CUP SET SCREW
LOCK WASHER
FLAT WASHER
HEX NUT
SILCONE SEALANT
If your SUV does not have the factory air compressor,
please go directly to STEP 20.
SUVs with the air compressor only.
STEP 19
Mount the air compressor back into position.
STEP 18
From under the vehicle, place the supplied fender washers,
flat washers, lock washers and then hex nuts onto each
protruding socket cup set screw and secure. Adjust the
amount of exposed thread on each cup set screw if
necessary keeping in mind that leaving too much exposed
tread will prevent the re-installation of the air compressor
and or the plastic wheel well liner.
Note: For added protection, it is recommended that
you apply a bead of silicone between the vehicle and
the fender washer. After the bolt assembly is tightly
secured, it is also recommended that vehicle under-
coating material is applied to the exposed assembly.
Continued on Next Page
SB-GM-TRLBLZR/10W3v3_INSTR_SKU#011184
STEP 15
Note: Before drilling, make sure that you are not going
to be drilling into any gas lines, brake lines, transmission
lines, electrical wiring, transfer case (4x4 vehicles)
or anything else that might cause a reduction in your
weekly pay. Always wear eye protection when drilling!
With a drill and a 1/2-inch drill bit, drill through the
impression made in the wax square and into the vehicle’s
wheel well.
Remove the wax squares.
STEP 14
Thread the supplied pair of socket cup set screws into
the bottom of the Stealthbox
®
, leaving 1/2-inch of thread
exposed. Position the Stealthbox
®
in the mounting location
and press down on it firmly.
Remove the Stealthbox
®
carefully, leaving the wax squares
in place. The socket cup set screws will leave impressions in
the wax.
STEP 13
Place one of the supplied wax squares, so the side of the
wax square is flush against the plastic side panel and the
middle of the wax square measures 7-inches from the front
protrusion of the side plastic panel.
Not pictured. Place the second supplied wax square, so
the side of the wax square is flush against the plastic side
panel and the middle of the wax square measures 7-inches
from the rear of the wheel well to the back of the SUV.
STEP 12
Use a hand held rotary tool (Dremel
®
) with cutting bit, to
cut out the side panel for the compressor switch panel.
Remember the hole for the hose nozzle.
STEP 16
Run speaker wire from the amplifier location to the
Stealthbox
®
location and check for proper operation of
the woofer.
Page 2 • JL Audio, Inc 2005
7-inches
