Specifications:
Enclosure Type: Ported
Driver Type: 10W6v2-D4
Nominal Impedance: 2Ω per woofer / can be rewired for 8Ω per woofer
Cont. Power Handling: 400Watts per woofer / 800Watts for system
JL Audio recommends using a high quality amplifier such as the JL Audio 500/1 or the JLAudio 1000/1. The diagram below shows
the recommended crossover, infrasonic filter and equalizer settings for either the 500/1 or the 1000/1 when being used to power
your Stealthbox®.
Included Hardware:
1) 3” x 3’ wax Square
1) 3/8”-16 x 2-1/4” Socket Cup Set Screw
1) 3/8” x 1-1/4” Fender Washer
1) 3/8” Flat Washer
1) 3/8” Split Lock Washer
1) 3/8” - 16 Hex Nut
10369 N. Commerce Pkwy, Miramar, Florida 33025-392 Phone: 954.443.1100 Fax: 954.443.1111
The JL Audio 500/1 or the JLAudio 1000/1 is a very versatile audio component. Please consult the owner’s manual for
detailed information about installing and tuning this amplifier.
➔➔➔
STEP 6: Run speaker wire to the/each enclosure
and attach to the speaker terminal cup. Check the
woofer(s) for proper operation at this time.
STEP 7: Back out the/each socket cup set screw
to expose about 1-1/2”.
Place the socket cup set screw through the mount-
ing hole that was drilled, inside the truck.
From the under side of the truck, place a supplied
fender washer, flat washer, lock washer and then hex
nut onto the/each socket cup set screw.
Secure tightly, using a 14mm socket and ratchet.
STEP 8: Lower the rear seat and replace all
removed contents.
➔
SB-GM-SXT/10W6v2, JL AUDIO, Inc 2006
Sheet SKU#011199 Revision 1/12/2006 Page 2
www.jlaudio.com
Mid/High Frequency Driver Information:
CONGRATULATIONS!
INSTALL COMPLETE.
ZR650-CSi
TR400-CXi
Front Location Driver Size:
6.5” Separates
Applicable JL Audio Products:
TR,VR,XR & ZR650-CSi
Rear Location Driver Size:
4”x 6”
Applicable JL Audio Products:
TR400-CXi
Cont.
From
Previous
Page
Difficulty Of Installation:
