Specifications:
Enclosure Type: Sealed
Driver Type: 12W6v2-D4
Nominal Impedance: 2Ω
Cont. Power Handling: 400 Watts
JL Audio recommends using a high quality amplifier such as the JL Audio 500/1. The diagram below shows the recommended
crossover, infrasonic filter and equalizer settings for the 500/1 when being used to power your Stealthbox®.
Included Hardware:
(2) 3” x 3” Wax sheets
(2) 3/8”-16 x 2-1/4” Socket Cup Set Screw
(2) 3/8” x 1-1/4” Fender Washer
(2) 3/8” USS Flat Washer
(2) 3/8” - 16 HEx Nuts
(2) 1/2”(w) x 1”(od) Spacers
(2) 12mm x 70mm Hex Cap Screws
10369 N. Commerce Pkwy, Miramar, Florida 33025-392 Phone: 954.443.1100 Fax: 954.443.1111
The JL Audio 500/1 is a very versatile audio component. Please consult the owner’s manual for detailed information
about installing and tuning this amplifier.
➔➔➔
STEP 23: Replace the jack and the jack tools, that
were removed in STEP 3.
STEP 24: Secure the spare tire onto the rack and
replace the tire cover.
➔
SB-GM-HUMR2/12W6v2, JL AUDIO, Inc 2004
Sheet SKU#011182 Revision8/5/2004 Page 4
www.jlaudio.com
Mid/High Frequency Driver Information:
CONGRATULATIONS!
INSTALL COMPLETE.
ZR650-CSi
XR525-CXi
Front Location Driver Size:
6.5”(door) & Tweeter(A-pillar)
Applicable JL Audio Products:
TR,VR, XR, ZR 650-CSi
Rear Door Location Driver Size:
5.25”
Applicable JL Audio Products:
TR,VR, XR525-CXi
Rear Cargo Location Driver Size:
2.25”
Applicable JL Audio Products:
N/A
Cont.
From
Previous
Page
Difficulty Of Installation:
