➔
➔
➔
STEP 7: With the hardware from STEP 4.
From under neath, attach the Stealthbox to the
bracket.
Secure tightly using an open end wrench.
STEP10: *CAUTION*
Before drilling, make sure that you are not going to be
drilling into any gas lines, brake lines, transmission lines,
electrical wiring, transfer case(4x4 vehicles) or any-
thing else that might cause a reduction in your weekly
pay. Always wear eye protection when drilling.
With the use of a 1/2” drill bit and drill. Drill out the
jack bracket and floor. Use the hole of the jack brack-
et as the drilling guide, as pictured.
Cont.
From
Previous
Page
Continued on Next Page ➔
➔
STEP 8: With the supplied hardware, attach the
jack bracket to the front of the Stealthbox.
STEP 11: Attache the jack bracket to the floor,
using the supplied hardware.
Place a 3/8” lock washer and 3/8’ flat washer onto
the 3/8”-16 x 2 bolt.
From inside the truck, slide the bolt through the
hole of the jack bracket and floor.
From under the truck, place the 3/8” fender washer,
3/8” flat washer and 3/8”-16 nut onto the protrud-
ing bolt.
Secure tightly.
➔
STEP 12: On the back side of the plastic jack
cover, there are two plastic guides.
Grind these guides off.
The picture above shows the guides already ground
off.
STEP 9: From under the truck, remove the heat
shield.
SB-GM-CLREXT/10W3v2, JL AUDIO, Inc 2005
Sheet SKU#011195 Revision 5/19/2005Page 2
www.jlaudio.com
➔
➔
