Specifications:
Enclosure Type: Acoustical Suspension (Sealed)
Driver Type: 10W3v2-D2
Nominal Impedance: 4Ω
Cont. Power Handling: 300Watts
JLAudio recommends using a high quality amplifier such as the JL Audio 250/1. The diagram below shows the recommended
crossover, infrasonic filter and equalizer settings for the 250/1 when being used to power your Stealthbox®.
Included Hardware:
(2) 3/8” Split Lock Washer
(2) 3/8” x 1-1/4” Fender Washer
(2) 3/8”-16, 2-1/4” Socket Cup Set Screws
(2) 3/8” - 16 Hex Nuts
(2) 3”x 3” Wax Squares
10369 N. Commerce Pkwy, Miramar, Florida 33025-392 Phone: 954.443.1100 Fax: 954.443.1111
Input Sens.
Left Ch.
Right Ch.
Left Ch.
Right Ch.
Filter Freq. (Hz)
The JL Audio 250/1 is a very versatile audio component. Please consult the owner’s manual for detailed information
about installing and tuning this amplifier.
➔
➔
STEP 50: Snap the dash trim panel back into place
from STEP 3.
STEP 51: Place the front seats back into place
from STEP 1.
Remember to reconnect the wiring connection
under the seats.
➔
SB-GM-BURBCNSL/10W3v2, JL AUDIO, Inc 2005
Sheet SKU#011167 3/08/2005Page 8
www.jlaudio.com
Mid/High Frequency Driver Information:
CONGRATULATIONS!
INSTALL COMPLETE.
XR650-CSi
TR400-CXi
VR650-CXi
Front Location Driver Size:
6.5” separates
Applicable JL Audio Products:
TR,VR,XR & ZR 650-CSi
Rear Location Driver Size (TRUCKS):
4”x6”
Applicable JL Audio Products:
TR400-CXi
Rear Location Driver Size (SUV’s):
6.5”
Applicable JL Audio Products:
TR,VR & XR 650-CXi
Cont.
From
Previous
Page
Difficulty Of Installation:
