JL Audio C2-690tx-11012008 Manual

next previous

4 | JL Audio - C2-690tx Owner’s Manual

SPEAKER INSTALLATION

Thespeakershouldbeinstalledinoneofthe

followingwaysdependingonlocation:



Bottom-Mount Locations:Ifyouwillbeusing

thefactoryspeakerwires,itmaybenecessaryto

changetheterminations.Thismaybeaccomplished

byusinganadaptorplugorsimplybycuttingthe

factoryconnectoroffandusingthesuppliedcrimp

connectorstoterminatethespeakerwires.The

largeconnectorisforthepositiveterminalandthe

smallconnectorisforthenegativeterminalofeach

speaker.Youmayalsochoosetorunnewspeaker

wires.Whichevermethodyouchoose,observe

correctpolarityinyourconnections.Ifyouare

unsureaboutanyoftheseissues,contactyour

JLAudiodealerforinstallationassistance.

WARNING



Double check the clearance for both speakers

before proceeding. Many cars are different from

one side to the other!

Yournewspeakershavebeendesignedtoinstall,

withoutmodifications,intomostvehiclesthataccept

a6x9inchspeaker.Mostfactory6x9inchspeakers

usefourmountingscrewsorboltswhichwilllineup

withthemountingholesonyourC2-690txspeakers.

Thespeakershouldfitsothatnoairleaksaround

themountingflange.Airleakswillcauseasevere

degradationinsoundquality.

Sealanyairleakswithsilicone,ropecaulkor

similarsealantmaterial.Installasshowninthe

diagramhere,usingthesuppliedbottom-mount

spacerringsandthesuppliedscrewsandmounting

clips.Hand-tightenthescrewsevenlytoavoid

bendingthespeakerframe!

WARNING

Hand-tighten the screws evenly in a criss-cross

pattern to avoid bending the speaker frame or

stripping the mounting clips.