39
Technical Assistance
Q: Why is the display shifted or changed sizes when I switch display
modes?
Explain and Suggestion:
Some monitors lack auto-sizing features or just do not synchronize
properly to the video board output. In some cases, horizontal and
vertical display adjustments may be necessary. Use the monitor control
panel functions to adjust screen.
In other cases, mode type and refresh rate adjustments may be
necessary. Use the utility program, which is provided by video card
manufacturer or production developer to center the display with normal
type (mode 3), and to reduce (decrease) the refresh rate with the
monitor's specification.
Q: What kind monitors can display 800x600 modes or higher
resolution mode?
Explain and Suggestion:
To display 800x600 resolutions at 60Hz refresh rate, the monitor must
be capable of synchronizing a 31.5KHz horizontal scan rate (e.g., NEC
2A, 3D). At 72Hz refresh rate, the monitor must be capable of
synchronizing a 48.0KHz scan rate (e.g., Sony HG 1304, NEC 4D, 5D,
Seiko 1450).
To display 1024x768 interlaced mode; the monitor must be capable of
synchronizing a 35.5KHz horizontal scan rate (e.g., NEC 3D, Seiko
1430 or 1440). To display 1024x768 non-interlaced mode at 60Hz, the
monitor must be capable of synchronizing a 48.7KHz scan rate (e.g.,
Sony HG 1304, NEC 4D, 5D, Seiko 1450).
To display 1024x768 non-interlaced mode at 70Hz, the monitor must
be capable of synchronizing a 56.4KHz scan rate (e.g., NEC 4D).
Q: Windows screen won't come up, it kicks back to
DOS prompt. Why?
Explain and Suggestion:
Windows® 95
Inadvertently, certain configuration files (e.g., msdos.sys, and
command.com) have been changed in the system. Proceed to correct
that, is re-boot the system with a system (Windows® 95) formatted
floppy diskette.
