SECTION 12—BATTERIES
Part No.1106645 58 Nutron® Series
Battery Clamp Method
ƽ WARNING
The battery clamp of the POSITIVE (+) battery terminal/post MUST be mounted in
the position shown in FIGURE 12.7, otherwise the battery box top cannot be
installed properly.
NOTE:Forthisprocedure,refertoFIGURE 12.7,FIGURE 12.8andFIGURE 12.9.
FIGURE 12.7 Connecting Battery Cables - Battery Clamp Method
1. Performone(1)ofthefollowing:
•IfthebatteryclampofthePOSITIVE(+)batteryterminal/postisNOTmountedin
theorientationshowninFIGURE 12.7,performthefollowing:
i. LoosenthehexnutthatsecuresthebatteryclamptothePOSITIVE(+)battery
terminal/post.
ࣼ CAUTION
When tightening the clamps, always use a box wrench. Pliers will “round off” the
nuts. NEVER wiggle the battery terminal(s)/post(s) when tightening. The battery
may become damaged.
ii. RemovethebatteryclampfromthePOSITIVE(+)batteryterminal/post.
iii. RepositionthebatteryclamponthePOSITIVE(+)batteryterminal/postas
showninFIGURE 12.7.
iv. Securelytightenthehexnutthatsecuresthebatteryclamptothepositive(+)
batteryterminal/post.
•IfthebatteryclamponthePOSITIVE(+)batteryterminal/postispositionedas
showninFIGURE 12.7,proceedtoSTEP2.
POSITIVE (+) Terminal/Post
(Note position of clamp)
NEGATIVE (-)
Terminal/Post Clamp
Hex Nut
Correct Orientation of the POSITIVE (+) Terminal/Post Clamp
Group 22NF Battery
