Invacare Pronto M61 Manual

A SERVICE OF

next previous

SECTION 12—ELECTRONICS

Part No 1125085 73 Pronto® M51™and M61™with SureStep®

5. Usingthethreehexmountingscrews,spacersandlocknutssecurethemounting

brackettothethreemountingholesofthearmframe.

6. Ifnecessary,performthefollowingtorepositiontheadjustmentlock:

A. Slidetheadjustmentlockfromthemountingbracket.

B. Rotateadjustmentlock180°andslideadjustmentlockovertheoppositeendofthe

mountingbracket.

7. Slidejoystickmountingtubethroughthemountingbrackettothedesiredposition

andsecureadjustmentlocktotubebyturningleveronadjustmentlock.

FIGURE 12.2 Repositioning the Joystick

ASBA Seat

NOTE:Forthisprocedure,refertoFIGURE 12.3onpage 74.

1. Turntheleverontheadjustmentlocktoreleasetheadjustmentlockfromjoystick

mountingtube.

2. Removethejoystickmountingtubefromthewheelchair.

3. Removethethreehexscrewsthatsecurejoystickmountingbracket,thethreadedhole

halfclampandtheopenedhole

halfclamptothearmtube.

4. Repositionthethreadedholehalfclampandopenedholehalfclampontheopposite

armtube.Makesurethreadedholehalfclampisontheinsideofarmtube.

5. Whileholdingthetwohalfclamps,installthefronthexscrewintothetwohalfclamps.

Securelytighten.

6. Lineupmountingholesofthejoystickmountingbracketwiththemountingholesin

thetwohalfclamps.

7. Securethejoystickmountingbrackettothetwohalfclampswiththeremainingtwo

hexscrews.

8. Slidetubethroughthebrackettothedesiredposition.

9. Slideadjustmentlockoverendoftubeandsecureadjustmentlocktotubebyturning

leveronadjustmentlock.

NOTE:Ifadjustmentlockdoesnotfitovertube,rotate180°.

Hex Mounting Screws

Locknuts

Adjustment

Lock Lever

Mounting Bracket

Armrest

Plate

Spacers

Mounting Holes

on Arm Frame