Invacare Pronto M51 Base Manual

A SERVICE OF

next previous

SECTION 6—SEAT

Pronto

®

M51

™

Base with SureStep

®

42 Part No. 1148076

9. Gentlyallowweightofseatassemblytobesupportedbytheproprod.

NOTE:OnlyleavetheseatassemblyintheUp/Openpositionwhileperforminganynecessary

procedures.AlwayslowertheseatassemblytotheDown/Closedpositionwhennotservicingthe

wheelchair.Ensuretheseatislockedinplacebeforeusing.

Tilting the Seat Assembly Forward

1. Usingonehand,firmlygraspthefrontedgeoftheseatassemblyandliftuntilseat

assemblyisnolongersupportedbytheproprod.

2. Disengagetheproprodfromthefrontseatpostandsecureintoclip.

3. Usingbothhands,slowlytilttheseatassemblyForwardintotheDown/Closed

position.

ƽ WARNING

Ensure the two screws are fully engaged and the seat assembly is securely locked in

place before use - otherwise injury or damage may result.

4. Usingthetwoscrewsandlocknuts,securetheseatassemblytothetwofrontseat

posts.

FIGURE 6.1 Tilting the Seat Assembly (Formula CG Only)

Seat Assembly

Locknut

Prop Rod

Clip

Front Seat Post

Screw