Invacare MA90Z Manual

A SERVICE OF

next previous

SECTION 2—OPERATION

Part No 1148139 17 MA90 Series

Programming the Automatic Wireless Fowler Transmitter

1. Ensurethetransmitterisinsidethemattresspocketlocatedontherightsideofthe

mattressattheheadend.

2. Ensurethemattressisinaflatposition.

3. Ensurethecontrolunitispluggedin,andtheLCDdisplaysSTANDBY.

4. Performoneofthefollowing:

• MA90Z‐Performthefollowingsteps:

i. PressandholdtheTurnAngleandMaxInflatebuttons.

NOTE:TheFowlerLEDislitandLdisplaysintheLCDDisplay.

ii. Raisethebedto45°.

NOTE:ThecontrolunitwillbeepandwillreturntoStandby.

iii. Performoneofthefollowing:

• Cancel‐PresstheTurnAnglebuttontoexitFowlerTransmitterSetup

withoutlinkingtoatransmitter.

• Save‐Wait60secondswithoutpressingakey.

• MA95Z‐Performthefollowingsteps:

i. PressandholdtheHoldandMaxInflatebuttons.

ii. AUTOFOWLERLEARNMODEwilldisplay.

iii. PLACEBEDINFLATPOSITIONwilldisplay.

iv. CONTINUE‐>SELECTwilldisplay.

v. PresstheSelectbutton.

vi. PLACEBEDINFOWLER/UPRIGHTPOSITIONwilldisplay.

vii.TRANSMITTERDETECTEDwilldisplay.

viii.Thecontrolunitwillbeep.

ix. STANDBYwilldisplay.