A SERVICE OF

logo

SECTION 12—DISASSEMBLING/ASSEMBLING THE M71
Pronto® M71™ 108 Part No 1118377
Final Assembly
11. Connect the right motor lead to the right motor connector. Align the RED connectors
on both the lead and connector.
12. Connect the left motor lead to the left motor connector. Align the RED connectors on
both the lead and connector.
13. Replace the seat by sliding the rear clevis into the rear uprights and allow the front seat
latches to pivot into the front seat posts. Lift up on seat release lever to ensure seat is
securely locked in place.
14. Connect the joystick cable. Refer to Disconnecting/Connecting the Joystick
on page 97.
FIGURE 12.3 Final Assembly
Seat
Batteries
Side Frame
Attachment Points
(Typical both sides)
Left Side
Assembly
*Front
Shroud
Front Frame Support.
Release handle is
located underneath.
Footrest
Battery Tray
Right Side
Assembly
*Rear Shroud
*NOTE: Front and rear shrouds are removable but removing the shrouds is not required for
transporting.
NOTE: Wheelchair after 7/14/03 shown.