49
12
COMMANDMIC II™ HM-157
New2001
12
■ Set mode programming
Set mode is used to change the condition of the transceiver’s
functions and the microphone’s own functions:
Transceiver’s functions—
Scan type, Scan resume timer, Weather alert, Dual/Tri-watch,
Beep tone*
1
, LCD backlight*
1
, LCD contrast*
1
and Radio
PWR.
Microphone’s own functions—
Beep tone*
2
, LCD backlight*
2
and LCD contrast*
2
*
1
For transceiver setting
*
2
For microphone setting
In this section, instructions are for the microphone’s own func-
tions only. Refer to pgs. 32 to 34 for the setting of the other
functions. (Some functions cannot be selected from the
HM-157.)
DD
Entering Set mode
q Turn power OFF.
w While pushing [16•
9
], turn power ON.
• After a beep emission, a Set mode item appears at the channel
comment indicator.
e After the display appears, release [16•9].
r Push [16•
9
] to select the desired item, if necessary.
t Push [
YY
] or [
ZZ
] to select the desired condition of the item.
y Turn power OFF, then ON again to exit Set mode.
• Beep tone
You can select the silent operation
by turning beep tones OFF or you
can have confirmation beeps
sound at the push of a key by turn-
ing beep tones ON.
• LCD backlight
The LCD backlight brightness can
be adjusted from OFF, 1 (dark) to
7 (bright.)
•
“” scrolls at the channel
comment indicator.
• LCD contrast
The LCD contrast can be ad-
justable in 4 levels. 1 is the lowest
contrast, and 4 is the highest con-
trast.
•
“” scrolls at the channel
comment indicator.
!IC-M422.qxd 05.2.23 2:21 PM Page 49 (1,1)
