6
Hunter Fan Company 42819-01 • 11/14/06
7
42819-01 • 11/14/06 Hunter Fan Company
Wire Nut
All wiring must be in accordance with national and local electrical
codes and ANSI/NFPA 70. If you are unfamiliar with wiring, use a
qualifi ed electrician.
Wall switches are not included. Select an acceptable general-use switch
in accordance with national and local electrical codes.
4-1. Make sure the power to the outlet box and associated wall switch
location is still OFF.
4-2. To connect the wires, hold the bare metal leads together and place
a wire nut over them, then twist the wire nut clockwise until tight.
4-3. Connect the bare or green ground wired (grounded) from the
ceiling to the green ground wire (grounded) from the ceiling plate
and the green ground wire from the fan.
4-4. Connect the white wire (ungrounded) from the ceiling to the
white wired (ungrounded) from the fan.
4-5. Connect the remaining wires as follows:
Single Switch Wiring:
• e black wire from the ceiling to the black and the black/
white wire from the fan.
Dual Switch Wiring:
• e black wire from the ceiling to the black wire from the fan.
• e black/white wire from the fan to the wire for the wall
switch.
CAUTION: Be sure no bare wire or wire strands are visible after
making connections.
4-6
Turn the splices upward and push them carefully back through the
ceiling plate into the outlet box.
4-7 Spread the wires apart, with the grounded wires on one side of
the outlet box and the ungrounded wires on the other side of the
outlet box.
4 •Wiring the Fan
3 • Assembling and Hanging the Fan
Step 3-2
#8-32 x 1” Screw
Green
Ground Wire
3-1. Position the square hanger so that the green ground wire attached
to the square faces out of the large opening in the metal bracket.
3-2. Holding the wires out of the way, lift the motor assembly and
place the square hanger into the opening in the ceiling plate.
WARNING: Make sure the square hanger can not rotate in the
metal bracket. Failure to do so could result in the fan falling.
3-3. Install two locking screws through the holes in the side of the
metal bracket to secure the square hanger.
Step 3-1
Motor
Assembly
Square
Hanger
Step 3-3
Locking Screw
Green
Ground Wire
Wire Nut
Step 4-3
